sipjae.blogg.se

If this was triggered accidentally, turn off the siren by pullingĪfter adding your lock to the Nest app, the white button inside your home turns Privacy On the lock, you will hear a siren noise. Your lock’s deadbolt is unable to retract (unlock) or extend Wait aįew minutes before trying to unlock your door. Middle of an update, the keypad may be unresponsive. While your lock’s software is updating, you won’t be able to doĪnything on the lock. You can press the white button to check the status of Privacy Mode or hold the button to turn Privacy Mode on or off. The white button will only light up when it needs your attention. Hear: “Your lock couldn’t connect to any Nest products.” Lock is unable to connect for more than two minutes, you will If you press the white button and don’t take any action or if your

The lock has timed out after two minutes of inactivity. White button is used to turn Privacy Mode on or off. The lock has been added to your Nest account.”Īfter you’ve connected your lock to the Nest app, your lock’s Once you’ve connected the lock to the Nest app, you will hear: The lock is successfully connected to the Nest app.

How to install and set up the Nest × Yale Lock > Learn about connecting your lock to the Nest app in the article Use your Nest app to add the lock to your When you press the white button inside your home, you will

The lock is ready to be connected to the Nest app. Wake up may be still performed manually by clicking the Button 4 times.You will only see the lights below during setup and when connecting the lock to the Nest app. Setting wake up interval to 0 disables sending Wake Up notification to the controller automatically. no Z-Wave range) the device will go into Z-Wave communication standby and retry to establish connection with the main controller after the next time interval. The Button will wake up at each defined time interval and always try to connect with the main controller. Longer wake up time interval means less frequent communication and thus a longer battery life.Īfter successful communication attempt, the device will update configuration parameters, associations and settings and then will go into Z-Wave communication standby.Īfter failed communication attempt (eg.